Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Cable & Drum Replacement: The Summerlin Owner’s Guide
Genie cable and drum replacement in Summerlin typically runs $130 – $250 installed, and in most cases we can have a technician at your door the same day you call. The price covers the cable and drum set matched to your Genie model, the labor to re-spool and tension it correctly, and a documented photo record of the failed parts before we touch anything.
Owners usually find this problem the same way: a loud snap from the ceiling of the garage, a door that hangs crooked with one side lower than the other, or a cable sitting loose and tangled around the drum. In Summerlin, we see it most often on doors past their tenth summer. The desert heat cooks the galvanized coating off the cable, rust works in under the vinyl, and the strands start to fray one at a time until the cable lets go under load. It’s one of the few garage door failures where stopping is the right move. Don’t run the opener again until someone has looked at it.
Which Genie Models This Applies To
Cable and drum sets aren’t a Genie opener part, strictly speaking. They belong to the door. That said, Genie’s door-and-opener packages sold through big-box stores around Summerlin between roughly 2010 and 2022 use a handful of cable diameters and drum profiles, and matching the wrong one is where most of the trouble starts.
Here’s the compatibility detail most homeowners miss: the cable gauge has to match the drum’s groove. A 3/32-inch cable on a drum cut for 1/8-inch will sit loose in the groove, spool unevenly, and fail again inside a year. We measure the old cable with a caliper before we quote, and we check the drum’s cable slot depth against the new set. If your door carries a manufacturer label inside the jamb, that label lists the door’s model and often the cable spec. If it’s faded or gone, the measurements tell us what we need.
On OEM versus aftermarket: Genie-branded cable and drum sets are available, but for a door that’s ten to fifteen years old, a quality aftermarket set cut to the same spec performs the same and costs less. What matters is the wire rope construction (7×7 strand for garage doors, not the stiffer 1×19), the galvanizing, and the drum’s cast-metal quality. We’ll explain which we’re quoting and why before you agree to anything.
We’re an independent service provider working on Genie equipment, not affiliated with Genie or its parent company. We also service LiftMaster and Chamberlain setups across Summerlin, and the same matching discipline applies.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Genie Cable & Drum Replacement Is Failing

- A cable hanging slack or off the drum. The cable has jumped its groove or snapped at the drum’s edge, which takes the tension off that side of the door. If you see this, stop operating the door and call – the door’s weight is now held by one side only.
- The door rises crooked, one corner trailing. A frayed or stretched cable on one side lets that corner lag while the other leads. It’s the most common early warning, and it gets worse fast once it starts.
- Frayed strands or rust bleeding through the cable. Look along the cable’s length, especially near the drum and the bottom bracket. Broken outer strands and orange staining mean the cable is past its service life and due for replacement, not repair.
- A grinding or popping sound at the drum. The drum has worn its groove or the cable has started to cut into the casting. You’ll hear it most as the door first lifts off the floor, when the load is heaviest.
- The door slams down or drops a few inches when you let off the opener. A cable no longer holding tension lets the door’s weight win. This one is unsafe, so treat it as an emergency rather than a scheduling item.
Before
AfterReplacement Cost & What’s Included
For Summerlin, cable and drum replacement runs $130 – $250 installed. That’s a written, flat price quoted before any work begins, per Clause 1 of The Haven Standard. No “call for a quote,” no surprise line items at the end.
| What’s included | Detail |
|---|---|
| Cable and drum set | Matched to your door’s cable gauge and drum profile |
| Labor | Re-spool, tension, and balance check on both sides |
| Photo record | Images of the failed parts and completed work, delivered to you |
| Warranty | Backed by the 365-Day Done Right Promise |
What moves the price inside that range: door height, whether one or both cables and drums are being replaced, and whether the door has a low-headroom or high-lift track configuration that takes longer to work around. If we find a second issue – a worn roller, a bent track – we show you the photo and quote it separately. You decide. The number on the original quote doesn’t change unless you approve a change.
Importantly, cable and drum work is almost never done alone in practice. The torsion spring that counterbalances the door loads against those cables, so we inspect it at the same time. Spring repair in Summerlin runs $180 – $340, and we quote it separately, in writing, if it’s needed.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?

Here’s the honest split. What you can safely do: look at the cable from a distance and note whether it’s slack, frayed, or off the drum. Check the door’s balance by disconnecting the opener and lifting the door halfway by hand – it should stay put. Listen for the drum sounds. Photograph what you see.
What you shouldn’t do: anything involving releasing or re-tensioning the torsion spring, or re-spooling the cable under load. The torsion system stores enough energy to break a wrist or worse, and re-spooling a cable while the spring is under tension is how people get hurt. This isn’t scare talk – it’s the reason every reputable garage door company treats this as a two-person, properly-tooled job. Genie door systems are no different from any other brand on this point.
If the cable is slack, frayed, or off the drum, call us at (844) 797-3654. Written price first, photo record at the end. Same-day availability when you call during the day.
FAQs
Expect seven to twelve years on a Summerlin door. Our dry desert heat and intense UV accelerate galvanized coating wear, so cables here tend to fail a year or two sooner than they do in cooler, wetter climates. If your cable shows rust staining or broken strands, replace the set rather than waiting.
No. Cables and drums are wear parts, and once a cable has frayed or a drum has worn its groove, replacement is the only correct fix. Re-spooling a frayed cable or re-cutting a worn drum just sets up the same failure. Call (844) 797-3654 for a written price.
Most single-door Genie cable and drum replacements take 45 minutes to an hour and a half, including the balance check and photo record. If the springs or track need work alongside it, plan for two to three hours. We tell you the time estimate along with the price before we start.
We match the set to your door’s measured cable gauge and drum profile, then source from suppliers that stock genuine Genie-compatible and quality aftermarket specifications. We show you the part before installation and photograph it in place, so you know exactly what went in. Call (844) 797-3654 for a free estimate.
Contact

If your Genie door has a slack cable, a crooked lift, or a drum making noise, call (844) 797-3654 for a free estimate. We’ll give you the flat written price for cable and drum replacement in Summerlin before anyone touches the door, show you the photo record of what failed, and stand behind the work for 365 days. Same-day availability during the day, and emergency calls answered live around the clock. If you have a written estimate from another company, bring it in for a free second opinion – no code needed.
Written by the team at Servo Garage Doors Summerlin, serving Summerlin and nearby areas.