A Servo company - serving Summerlin, NV

Genie Weather Seal Replacement in Summerlin, NV

Raised-panel steelRaised-panel steel
Carriage houseCarriage house
Modern flushModern flush
Full-view glassFull-view glass
LiftMaster openersLiftMaster openers
Chamberlain openersChamberlain openers
Every visit starts with

Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included

We have financing partners for your new garage door*On approved credit; ask us about your options

You get a price before we start. It does not change when the pro arrives.

Get your free estimate

Genie Weather Seal Replacement: The Summerlin Owner’s Guide

We replace failed Genie weather seals across Summerlin for $150 to $600 installed, and most of that work is done same day because the seal is a stock-size part, not a special order. The bottom seal is the rubber or vinyl strip that runs inside the bottom aluminum retainer on your door; when it flattens, tears, or pulls loose, the door no longer meets the floor cleanly. Most Summerlin owners find out one of two ways: they see a line of daylight under a closed door, or they notice the door reversing on its own because something interrupted the safety beam near the floor.

Call (844) 797-3654

Key Takeaways

  • Genie weather seal replacement in Summerlin runs $150 to $600 installed, quoted in writing before we start.
  • Model matters less than retainer profile and track width; the seal has to match the physical channel it slides into.
  • Same-day repair is available, and we answer the phone around the clock.
  • Clause 4 is why the technician photographs the failed seal before quoting a replacement.

Which Genie Models This Applies To

Weather seals aren’t matched to your Genie opener. They’re matched to your door and the bottom retainer profile it uses, which is why this is often easier than it first looks. Genie openers like the ChainMax, SilentMax, and the older 2000-series units run the door, but the seal is a separate component with its own dimensions. Most residential Genie-equipped doors in Summerlin fall into one of a few retainer styles: a T-slot or T-end channel, a U-shape, or a round bead. What we measure is the retainer’s internal track width (commonly around 2 to 2.625 inches), the seal’s thickness, and the door’s width, since seals come in 16-foot and 9-foot runs that we cut and cap on site.

To identify yours, look for the model or serial plate on the opener housing, then photograph the underside of the door’s bottom edge. If you don’t want to measure anything, that photo is usually enough for us to confirm the right profile before we arrive. The OEM-versus-aftermarket call isn’t a big one here. Genie-branded seal is fine, and a quality aftermarket extrusion in the same profile does the job at a lower price, as long as the durometer (how firm the rubber is) and the retainer fit are right. We stock neither on a truck and don’t claim to. We order or pull the correct profile for your door.

Explore

Styles & brands we work with

  • Raised-panel steel
  • Carriage house
  • Modern flush
  • Full-view glass
  • LiftMaster openers
  • Chamberlain openers

Signs Your Genie Weather Seal Replacement Is Failing

Technician performing professional garage door spring repair and maintenance
Signs Your Genie Weather Seal Replacement Is Failing

A failing weather seal is quiet for a long time and then obvious. Here’s what we actually see on Summerlin doors, and what’s behind each one.

  • Daylight under a closed door. The seal has compressed or the retainer sits proud of the floor, so a strip of light shows through. That gap is your first sign the door isn’t sealing.
  • The door reverses without contact. A loose or torn seal hanging near the floor can interrupt the safety beam, which reads it as an obstruction. The opener reacts and sends the door back up.
  • A hard, brittle strip that cracks when you bend it. Desert heat and low humidity cure the rubber over a few summers. Once it’s stiff, it stops flexing and starts splitting.
  • Moisture or dust working in along the threshold. A flattened seal won’t form the wipe against the floor, so wind-driven dust and the occasional rain get under it.
  • The seal pulling out of its channel at one corner. Years of the door cycling up and down work the bead loose at the ends, and once one edge lets go, the rest follows.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade
BeforeBefore
AfterAfter

Replacement Cost & What’s Included

For Summerlin, Genie weather seal replacement comes in at $150 to $600 installed, parts and labor quoted together as one flat, written price before any work begins. That’s Clause 1 of The Haven Standard, and it means you see the number on paper, not a “call for a quote.”

What moves the price within that range:

Factor Effect on price
Single-car door (about 9 ft) Lower end of the range
Double-car door (about 16 ft) Higher end, more seal and more time
Standard T-slot retainer Straightforward swap
Bent or missing bottom retainer Retainer work adds to the job
Full jamb or perimeter seals replaced too Adds to the scope

The work carries the 365-Day Done Right Promise: if it isn’t right, we make it right, backed by The Haven Standard and a terms page rather than a handshake. Every visit closes with a documented photo record of what we found and what we installed, so you have proof of the seal you paid for.

DIY or Call Us?

professional garage door repair service
DIY or Call Us?

This is one of the safer garage door jobs, and we won’t pretend otherwise. A seal swap doesn’t involve high-tension springs or live wiring, so an owner with basic tools and some patience can often handle it. You can safely check the symptom yourself: bend a corner of the seal, measure your track width, and photograph the underside of the door. What trips people up is the retainer. Pulling an old, brittle bead out of a T-slot without cracking the aluminum, or trimming a 16-foot run square and capping both ends so it doesn’t shrink back, is where the job usually stalls. Get the profile or the cutoff wrong and the new seal won’t seat. We’d rather you save the afternoon and the second trip to the hardware store.

If the seal came loose because the door, tracks, or bottom retainer are out of alignment, that’s the real problem and the seal is only a symptom. We service Genie along with LiftMaster, Chamberlain, and every other major brand, so we’ll tell you plainly what failed. Call (844) 797-3654 and we’ll get you an exact written price for your Summerlin door.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Need Garage Door help nationwide? Licensed & insured · within the hour response · free estimates
Call (844) 797-3654
Local Service Coverage

Request a Free Estimate in Summerlin

Tell us what you need - Servo Garage Doors Summerlin responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch