Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateCraftsman Opener Logic Board Repair: The Summerlin Owner’s Guide
Craftsman opener logic board repair in Summerlin typically runs $120 – $320 installed, and most jobs are completed the same day. The logic board is the opener’s control center, the small PCB that reads your wall button and remotes, drives the motor, and watches the safety sensors. When it fails, the door either stops responding, reverses for no reason, or clicks and does nothing. Most Summerlin owners figure it out the same way: the remotes and wall button both quit at once, the breaker is fine, and the light on the opener still works. That pattern points squarely at the board.
We photograph the failed board before quoting a replacement. Clause 4 of The Haven Standard is the reason, and on this part it matters because a dead board and a bad wall console look identical from the floor.
Which Craftsman Models This Applies To
Craftsman sold openers under several model lines over the years, and the logic board is not interchangeable across them. The common families you’ll find in Summerlin garages are the 1/2 HP chain-drive and belt-drive units (model prefixes like 139.53, 139.54, and 139.56), the 3/4 HP belt-drive units, and the newer quiet belt models. The first four digits after 139. are usually the giveaway, and the full model number sits on a label on the back panel of the motor housing or under the light lens. Pull the label before you order anything.
Craftsman openers are built on Chamberlain and LiftMaster platforms, so the board from a Chamberlain unit of the same generation is often physically identical. That’s the compatibility gotcha most owners miss, and it’s also why aftermarket boards run $40 – $110 online while a genuine OEM board can run $90 – $180. The aftermarket board can work, but the connector layout and the learn-button position sometimes differ by a revision. When we source a part, we match by model number and board revision, not by brand name on the box.
We’re an independent service provider and not affiliated with Craftsman. We service Craftsman, and we also handle LiftMaster, Chamberlain, and Genie openers across Summerlin.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Craftsman Opener Logic Board Repair Is Failing

- Wall button and every remote quit at once. When both stop working, the receiver on the logic board has usually failed, not the remotes and not the battery.
- The door reverses immediately after closing. The board is misreading the safety sensor circuit, often because a solder joint on the sensor input has cracked with heat cycling.
- Relay clicks but the motor never turns. The control relay on the board is firing but the motor drive circuit isn’t, which points to a failed relay or a burned trace on the board.
- Erratic travel or the door stops partway. A failing board loses its limit settings, so the opener no longer knows where the open and close positions are.
- Nothing at all, but the light works. A burnt transformer or blown board fuse kills the logic while the light circuit stays alive, which tricks owners into thinking the opener is fine.
One NV-specific reality: Summerlin garage interiors routinely hit 110°F to 130°F in July and August, and that heat cycling is hard on electrolytic capacitors on the board. We see more board failures on units over eight years old here than in cooler climates, and the failure often shows up right after the first hot stretch.
See the difference
Before
After
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Logic board repair in Summerlin lands in the $120 – $320 opener repair range. The low end covers a board swap on an accessible unit with a stocked match; the high end covers a hard-to-match board, a board plus a wall console, or a unit mounted high in a tight garage.
| Item | Typical Range |
|---|---|
| Diagnostic visit with documented photo record | Included in the quote |
| Aftermarket logic board (matched by model and revision) | $40 – $110 |
| Genuine OEM Craftsman / Chamberlain board | $90 – $180 |
| Labor and calibration | Included in the installed price |
| Installed total | $120 – $320 |
Every job starts with a flat, written price and written scope under Clause 1 of The Haven Standard, so the number you agree to is the number on the invoice. When the technician leaves, you get a documented photo record of the failed board and the completed work. Repairs carry the 365-Day Done Right Promise, backed by The Haven Standard and its terms page.
DIY or Call Us?

There’s a safe slice of this you can check yourself. Confirm the wall button and remotes both fail. Confirm the opener has power and the light works. Reset the breaker for 30 seconds, then retest. Re-pair one remote by the manual if your model allows it. If all four of those check out, the board is the likely culprit.
What we don’t recommend is opening the motor housing and pulling the board yourself. The opener is on 120V line voltage inside that cover, the capacitors can hold a charge after power is off, and the board connectors are fragile in ways that turn a $120 repair into a full opener replacement. Beyond the electrical risk, the board has to be matched to the correct revision or the opener won’t learn its limits. If your model is one of the affected Craftsman units, call (844) 797-3654 and we’ll diagnose it the same day, with the price agreed in writing before we start.
FAQs
Most Craftsman logic boards last eight to twelve years, but in Summerlin’s heat a board can fail closer to the seven- or eight-year mark. The heat cycling on capacitors is the usual killer here, and a board that’s been running in an unvented garage in July tends to fail sooner than the manual suggests.
Rarely, and not on a Craftsman opener worth saving. Failed capacitors and relays are sometimes repairable by a board-level tech, but the labor often runs near the cost of a new matched board, and a board swap gives you a known-good part with a warranty. We quote the swap first because it’s the honest number.
Most logic board swaps are done in under an hour once we have the matched part on site. If the model needs a specific board we don’t have on hand, we’ll give you the timeline in writing before we schedule, and we don’t guess at it.
We match by full model number and board revision, pulled from the label on your motor housing, then source the OEM part or a quality aftermarket equivalent of the same revision. If the aftermarket version has a different connector layout, we use the OEM board. You see the part and the photo record before we close the job.
Call (844) 797-3654 for a free estimate. We answer live, 24/7, so a dead opener doesn’t sit broken overnight.
Written by the team at Servo Garage Doors Summerlin, serving Summerlin and nearby areas.