Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateCraftsman Weather Seal Replacement: The Summerlin Owner’s Guide
We replace Craftsman-compatible weather seal for a flat, written price of $110 – $220 installed in Summerlin, and on most model lines the swap is a same-day job once the correct profile is matched. The bottom seal (the flanged gasket that runs the width of the door’s bottom edge) is the part we replace most often here. Summerlin owners usually find it the same way: a fine sand-like drift appears on the garage floor after a windy March afternoon, or the first cool evening of fall sends a stream of cold air under the door, and the seal underneath has gone flat, cracked, or torn away from its retainer.
The seal fails quietly. You notice the draft before you notice the tear.
Key takeaways
- Installed price for Craftsman weather seal replacement in Summerlin: $110 – $220, quoted in writing before we start.
- Compatibility depends on three things: door thickness, retainer (track) style, and bottom width. Get one wrong and the seal either won’t seat or won’t seal.
- The U-shaped bulb and the flat blade seal are not interchangeable. We measure before we quote.
- We photograph the failed seal and the fit of the new one, and you get that record when the technician leaves.
Which Craftsman Models This Applies To
Craftsman bottom seals are sold by door, not by opener. The Craftsman name on your wall unit tells you what raises the door; the door and its bottom retainer tell you which seal fits. In Summerlin we run into three common arrangements on Craftsman-equipped doors:
- U-shaped bulb seal with a flange that slides into an extruded aluminum retainer along the bottom edge. Common on newer steel doors.
- Flat blade seal with a T-shaped flange pressed or slid into a narrow channel. Common on doors with a thinner bottom section.
- Wood or composite retainer with a nailed or screwed-on gasket. Older Summerlin garage doors in the western villages still turn up with this.
To identify the right replacement, measure the inside width of the door’s bottom section in inches (most single-car doors run 9 feet, most double-car doors 16 feet), confirm the retainer shape and channel depth, and note how the old seal attaches: slides in, presses in, or sits on a track. A seal cut two inches too short leaves a visible gap at one corner. A bulb that’s too tall for the door’s travel can drag on the concrete and wear out in a single season.
On the OEM-versus-aftermarket question for Craftsman-branded doors: aftermarket seal from reputable suppliers gives you the same EPDM rubber compound at a lower price, and it’s what we install more often than not. OEM parts matter most when the retainer is a proprietary extrusion, since a generic U-bulb will not seat in a custom channel. We measure the channel before we recommend either. Servo Garage Doors Summerlin is an independent service provider and is not affiliated with Craftsman.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Craftsman Weather Seal Replacement Is Failing

- Windblown sand or grit on the garage floor. The seal has lost its contact edge, either through a flat spot or a split at the corner, and dust is riding under the door on a Nevada wind.
- A draft at the bottom on the cool nights. The bulb has compressed permanently and no longer presses against the concrete; the seal looks fine from standing height but doesn’t touch.
- Water staining just inside the door after a monsoon burst. The seal has pulled loose from its retainer along one edge, or its flange has hardened and stopped gripping the channel.
- A cracked, brittle, or powdery texture on the rubber. Las Vegas Valley sun and dry air break down EPDM rubber faster than in cooler climates; a seal that sees direct afternoon sun can harden and crack inside three to five years.
- The door slams or the seal folds under itself. A too-tall seal or a warped bottom section is rolling the gasket under the door each cycle, and it’s wearing through at the fold line.
See the difference
Before
After
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Craftsman weather seal replacement in Summerlin runs $110 – $220 installed. That range covers the seal itself, the labor to remove the old one and seat the new one, and the fit check that confirms the door closes flat on both sides.
What drives the range:
- Door width. A 9-foot single door sits at the low end; a 16-foot double door at the high end.
- Retainer type. A slide-in aluminum track is quick. A rotted wood retainer that needs repair first adds time and material.
- Seal profile. A standard U-bulb is cheaper than a custom-fit bulb for an unusual channel.
- Access. Tight clearance under the door edge or a door that needs lifting for the swap adds labor.
We quote a flat, written price and written scope before any work starts, Clause 1 of The Haven Standard. That price is what you pay, not a starting figure that creeps once the door is up. The work is covered by the 365-Day Done Right Promise: if the seal doesn’t seat right, we come back and make it right.
DIY or Call Us?

You can safely check the seal yourself. Run your hand along the bottom edge of the closed door, feel for gaps or a hard, crumbly texture, and note where the seal attaches. That measure will make our quote faster and more accurate.
The risk comes at installation. The bottom seal sits under a door that weighs a few hundred pounds, held by a torsion spring and cables under high tension. Reaching under the door while it’s open, or lifting it past its balance point to reach the retainer, can let the door drop or the spring let go, and both cause serious injury. We don’t recommend homeowner work on the bottom edge of an open door for that reason. Our technicians have up to 11 years of experience; every job includes a documented photo record of what we found and what we installed. Call (844) 797-3654 for a written price estimate.
FAQs
Expect three to five years in Summerlin for a seal on a door that faces the afternoon sun, and five to seven for a shaded or north-facing door. Dry air and direct heat harden the rubber and break down the flange, so the seal on a west-facing door wears faster than the same seal on a shaded one. Call (844) 797-3654 and we’ll give you a written quote to swap it.
Sometimes. A loose flange on the last few inches at one end can be re-seated, and a small tear can occasionally be closed with a patch. But once the bulb has flattened, cracked, or pulled away along a long run, the rubber is past the point where repair holds, and replacement is the cheaper of the two. We’ll tell you which it is in writing before anyone touches the door. Call (844) 797-3654 for a free estimate.
Most Craftsman weather seal replacements take 30 to 60 minutes once the correct profile is on-site. A straight slide-in U-bulb on a standard door runs closer to 30 minutes; a wood retainer that needs repair or a custom profile runs longer. Same-day availability is common on this swap when we have the match confirmed. Call (844) 797-3654 to check today’s openings.
We measure the retainer and door width, then match the seal to the profile today. We do not carry stock on a truck; we confirm the correct seal from a measured specification, not from a guess at the model year. Every visit ends with the documented photo record of what we found and what we installed. Call (844) 797-3654 for a written price before any work starts; free second opinions on any competing written estimate are welcome.
If your Craftsman door needs a new weather seal, call Servo Garage Doors Summerlin at (844) 797-3654 for a free estimate. We also service LiftMaster, Chamberlain, and Genie openers, along with every major door brand. The price is written and agreed before any work starts, the technician photographs the failed seal before quoting the replacement, and the record is in your hands when the job is done. Estimates are free, and the call is answered by a live person.
Written by the team at Servo Garage Doors Summerlin, serving Summerlin and nearby areas.