Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateAmarr Cable & Drum Replacement: The Summerlin Owner’s Guide
We replace Amarr cable and drum assemblies with Amarr-compatible hardware, and the installed price in Summerlin runs $130 – $250 for the cable repair and drum work, quoted flat and in writing before anything is touched. Cables and drums fail on a different timetable than springs, so we treat them as their own job. Most Summerlin owners find out something’s wrong the morning the door comes down crooked, or when they see a cable hanging slack off one drum and hear metal dragging across metal as the door travels.
Cables and drums are the lift linkage of your door. The cables wind around the drums at each end of the torsion shaft and take the door’s full weight on every cycle. When one goes, the door stops lifting evenly and the other side carries a load it was never sized for. That’s the failure picture we see most in Summerlin, and it’s why we ask you to stop cycling the door once anything looks off.
Key Takeaways
- Amarr cable and drum replacement in Summerlin typically runs $130 – $250 installed, quoted in writing first.
- We match the drum to your Amarr model and door weight, not to a generic size.
- Cables are high-tension. This is not a DIY part.
- We’re an independent service provider, not affiliated with Amarr.
- Every visit closes with a documented photo record of the failed part and the new installation.
Which Amarr Models This Applies To
Amarr builds sectional doors across several product lines, and the cable and drum hardware is sized to the door’s weight and track radius. That’s the compatibility gotcha most owners miss: the drum isn’t one universal part. A 12-inch drum and a standard drum wind a different length of cable per turn, and putting the wrong one on a door changes its balance. The model you own determines which drum and which cable length you need, and the only reliable way to match it is the tag on the door plus a measurement of the drum and the door’s weight.
Look for the Amarr label inside the door panel or on the end stile; it carries the model and often the door size. If the tag is gone, we measure the drum physically and check the door’s balance to confirm the right replacement. On the OEM-versus-aftermarket call: Amarr-compatible aftermarket drums and cables are made to the same specs and are what we install on most jobs, because the fit is right and the part holds up in Summerlin heat. Where the door is newer and the original hardware is still obtainable, that’s a conversation we have with you before ordering, not after.
Two things that actually degrade these parts in Southern Nevada: the dry heat, which dries out the cable lubricant and lets strands wear against each other, and the daily cycle count on doors that face west and bake in afternoon sun. A cable that lasts years in a milder climate wears faster here when it goes unlubricated.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Amarr Cable & Drum Replacement Is Failing

- A cable hanging slack or off the drum. The cable has jumped its groove or a drum has worn and let it slip. Both mean the door is lifting on one side only, and the other cable is now overloaded.
- The door travels crooked. One side rises faster than the other because a drum is slipping or a cable is stretched. This puts twisting stress on the panels and track.
- Frayed or kinked cable strands. You’re seeing broken wire strands where the cable bends around the drum. A frayed cable is near the end of its life and can snap.
- Grinding or scraping as the door moves. A worn drum groove or a cable riding the drum edge makes metal-on-metal noise. It gets worse as the drum wears.
- The door feels heavy or won’t stay up. If the drum or cable is failing, the balance is off and the door takes weight it shouldn’t. Stop using it and get it looked at.
See the difference
Before
After
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Cable and drum replacement in Summerlin lands in the $130 – $250 range for the cable repair, and the drum side is folded into that same flat quote when both are serviced together. The range moves with a few things: whether one cable or both need replacing, drum wear, and whether the torsion shaft needs attention once we’re in there. You get the written price and written scope before any work starts. Clause 1 of The Haven Standard is exactly this: no “call for a quote,” no surprise figure after the work is done. You see the number, you agree to it, then we touch the door.
The quote covers the Amarr-compatible cable and drum hardware, the labor, rebalancing the door, and the documented photo record you receive when we leave. The 365-Day Done Right Promise backs the work: if the repair isn’t right, we make it right. Our technicians have up to 11 years of experience on this hardware.
DIY or Call Us?

You can safely check a few things yourself. Look at both cables for fraying or slack, watch whether the door rises evenly on both sides, and listen for grinding. Write down what you see. That’s where the safe DIY ends.
Cables on a torsion system carry the door’s entire weight under high tension. Releasing or re-seating one by hand can let it snap back with enough force to cause serious injury, and getting a drum rewound wrong leaves the door unbalanced and dangerous. We don’t hand out step-by-step instructions for this part because the risk isn’t worth it. That’s why we photograph the failed cable and drum before quoting, per Clause 4, so you can see exactly what went wrong and why the replacement is the right call. Call (844) 797-3654 and we’ll get a technician out.
FAQs
How long do Amarr cables and drums last?
Most last somewhere in the range of 8 to 15 years depending on cycle count and lubrication, and Summerlin’s dry heat shortens that when the cables aren’t kept lubed. A door cycling six or more times a day wears them faster than one used twice. Call (844) 797-3654 for a look if your door is older and acting up.
Can the cable or drum be repaired instead of replaced?
No. A frayed cable or a worn drum can’t be repaired, only replaced, because a repaired cable has lost the strength the door depends on. We replace the failed part with Amarr-compatible hardware sized to your door. We’ll tell you honestly if only one side needs it.
How long does the swap take?
Usually an hour to two hours for a straightforward cable and drum replacement, longer if the torsion shaft or track needs attention once we’re in. We give you the flat price and scope before we start so there’s no clock anxiety.
How do you source the part?
We match the drum and cable to your Amarr model and door weight from the label and a physical measurement, then order Amarr-compatible hardware to that spec. We don’t carry parts on a truck, and we won’t fit a generic drum that changes your door’s balance. Call (844) 797-3654 for a free estimate.
We also service LiftMaster, Chamberlain and Genie hardware, and we’re a free second opinion on any written estimate you’ve brought from another company.
If your Amarr door is pulling crooked, dragging a cable, or making grinding noises as it moves, pick up the phone and call Servo Garage Doors Summerlin at (844) 797-3654 for a free estimate. You’ll get a written price before any work starts, a live person on the other end, and a photo record of exactly what we found when we leave.
Written by the team at Servo Garage Doors Summerlin, serving Summerlin and nearby areas.