Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateAmarr Weather Seal Replacement: The Summerlin Owner’s Guide
We install Amarr-compatible weather seal replacement in Summerlin for $110 – $220 installed, and most of these are same-day jobs when we have the right profile on the van. If your seal is cracked, flattened, or letting daylight under the door, that range covers removal of the old seal, a new OEM-spec or quality aftermarket bottom seal matched to your Amarr model, and clean-up when we leave.
Summerlin owners usually spot the problem the other way around: not by looking at the seal, but by feeling the draft. The door closes, the gap along the floor is visible from the driveway, or the garage stays warm in July even though the door is shut. Then the ants or the mice show up, or a scorpion, and the seal suddenly gets attention. That is the moment this page is for.
Key Takeaways
- Amarr weather seal replacement in Summerlin typically runs $110 – $220 installed, parts and labor together.
- The Amarr bottom seal is a specific profile that does not interchange with Clopay or Wayne Dalton seals; matching it matters more than the price.
- Nevada sun and dry heat degrade the seal faster than in most climates; a five-to-seven-year replacement cycle is realistic in Summerlin.
- We are an independent service provider and are not affiliated with Amarr.
- Written price before any work starts, photo record when we leave.
Which Amarr Models This Applies To
Amarr builds a broad range of residential doors, and the bottom seal is not one universal strip. The profile that fits an Amarr Stratford or Heritage series sectional door is often a different shape and width than what fits an Amarr Lincoln or Oak Summit series, and the older Stratford doors with the pinch-resistant bottom section use a different retainer than the newer models with a standard U-shaped retainer. This is the single most common compatibility miss we see on this part: a homeowner orders a generic “Amarr seal” online, it arrives, and it will not seat into the retainer that is actually on the door.
To identify the right part, we look at three things. First, the model label on the inside of the top section, usually a sticker near the top panel corner or behind the hinge on the end stile. Second, the retainer channel itself: the metal or vinyl strip the old seal slides into, measured at the inside width in fractions of an inch. Third, the bottom section profile on the door itself, since some Amarr bottom sections are flat and others have a raised lip that changes the seal depth by a quarter inch or so. We measure all three and match to the Amarr spec, not to a photo on a listing.
The OEM-versus-aftermarket decision comes down to fit and material. Genuine Amarr replacement seals are a direct match and hold up the way the door was designed to close. A quality aftermarket equivalent in the right profile and durometer (the rubber’s hardness) can do the same job for less, and we stock both paths in the price. What we do not do is stretch a Clopay or Wayne Dalton seal to fit an Amarr retainer and call it good, because it is not, and you will be back in twelve months. We service LiftMaster, Chamberlain, and Genie openers as well, so if your weather seal replacement turns into a door tune-up, one visit covers it.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Amarr Weather Seal Replacement Is Failing

A failed bottom seal does not usually announce itself. It shows up in small ways first, and Summerlin owners learn to read the signs once they have replaced one. Here are the five we see most often.
- Visible daylight or a draft under the door. When you stand inside with the garage door closed and can see light along the floor line, the seal has flattened or pulled away from the retainer. In Summerlin’s summer heat the rubber compresses more than in a cooler climate, so the first gap usually appears in July and August.
- Cracks, splits, or a chalky surface on the seal. UV exposure and dry desert air break down the rubber over time, and the surface goes from flexible to brittle. If you can press your thumbnail into the seal and the indentation stays, it has lost its memory and won’t seal a door closing on it.
- Pests getting in. Ants, mice, and scorpions come through a gap the size of a nickel. Once the seal loses contact with the floor, the garage is open to anything that lives in the dirt around a Summerlin home.
- Water intrusion during monsoon season. Summerlin sits on the west side of the valley where monsoon rain in summer can run under a failed threshold seal. If you find water pooling at the back of the garage after a storm, the bottom seal is a likely cause.
- Retainer separation or a seal that has slid out of the track. The steel retainer can rust or bend, letting the seal pull loose at one end. That is not a seal failure alone; it usually means the retainer needs attention too, and the price covers checking both.
Before
AfterReplacement Cost & What’s Included
Amarr weather seal replacement in Summerlin runs $110 – $220 installed. That range assumes the seal itself is the only part. The lower end is a single-wide door with a standard bottom seal in the right profile. The upper end is a double-car door, a non-standard profile that needs ordering, or a job where the retainer also needs adjustment.
Here is what drives the range and what’s in it:
| Line Item | Range |
|---|---|
| Weather seal replacement, single door | $110 – $160 |
| Weather seal replacement, double door | $160 – $220 |
| Retainer repair or adjustment, if needed | Quoted separately |
| Full garage door service call (other issues found) | $150 – $600 |
Every quote is a flat written price with a written scope before we touch the door. That’s Clause 1 of The Haven Standard, not a slogan. We photograph the failed seal and retainer, show you what we found, and you see the exact seal and profile before we install. If your door needs other work, we price that separately and you decide; we don’t roll it into the seal quote to make the number look better. The weather seal replacement carries our 365-Day Done Right Promise: if the seal fails to fit or fails to seal within a year, we make it right. That’s the paper trail, not the handshake.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?

Weather seal replacement is safer than spring or cable work. There are no high-tension springs or cables involved on the bottom seal itself, so an owner who is comfortable on a ladder and has a pry bar and some patience can replace a straight U-channel seal on a standard door. That said, three things go wrong in Summerlin that the average DIY job does not account for.
First, the wrong profile. A generic strip will sort of fit, sort of seal, and blow out the first hot season. Second, the retainer on an older Amarr door is often rusted or bent, and pulling the old seal can bend it further, so the new seal slides in crooked or not at all. Third, the door itself. On some doors, a seal that will not stay in the retainer means the bottom section or the retainer is out of alignment, which becomes a track realignment issue ($120 – $240) rather than a seal issue. We do not recommend pushing a door onto a hard floor or forcing a seal into a warped retainer.
If you want to check first, look at the seal with the door closed, run your hand along the floor line, and measure the width of the bottom section and the inside of the retainer. If those numbers match a standard profile and the retainer is straight, you can probably handle a straight seal swap on your own. If anything is bent, missing, or the seal won’t stay seated, that’s the call.
Call (844) 797-3654 and we’ll get a written price out to you. If you already have a written estimate from another company for a seal replacement, bring it in and we’ll do a free second opinion on the paperwork. No coupon or code needed.
FAQs
Expect five to seven years on a bottom seal in Summerlin’s climate, and sometimes less if the door faces west or sits on a south-facing exposure. UV and dry heat age the rubber faster than humidity would; the surface goes chalky, the profile flattens, and the seal stops making contact with the floor. If your seal is five years old and already showing cracks, it is on the short end of the replacement window. Call (844) 797-3654 for a written price before you buy anything online.
Sometimes a section that has slid out of the retainer can be pushed back in and crimped, but that is a short-term fix, not a repair. If the rubber is cracked, brittle, or flattened, replacement is the only real correction. We check the seal and the retainer both, since a retainer that has rusted or bent will reject a new seal as quickly as it rejected the old one.
A single door is usually under an hour, and a double door is typically 60 to 90 minutes, assuming the correct profile and retainer are in place. If the profile needs to be ordered, we will tell you the lead time before we quote and schedule, so you’re not waiting for a surprise. Call (844) 797-3654 and we’ll give you a realistic window on your specific Amarr model.
We identify the door model and the retainer profile, then source a matched OEM-spec seal or a quality aftermarket equivalent in the correct profile and hardness. We do not carry parts on a truck, so we order to the door, not to a generic bin. You see the exact part in the written scope before install, and if the wrong profile shows up on the driveway, that’s on us to fix, not you to argue about.
Why Summerlin Owners Call Us for This Part

Weather seal replacement is one of those jobs where the part is cheap and the fit is everything. We have installed a lot of them, and the pattern is consistent: the door that gets the correct Amarr-spec seal the first time stops getting called back, and the door that got a stretched generic strip comes back within a season. Our technicians have up to 11 years of experience, and they photograph what came out and what went in so you have a record of the seal, the retainer, and the fit. Written price before any work starts. Photo record when we leave. And 18,000+ garage doors made right since 2015, every one under the same written-price rule.
We are an independent service provider and are not affiliated with Amarr. We work on all eight major brands, including Amarr, LiftMaster, Chamberlain, Genie, Clopay, Wayne Dalton, Craftsman, and Raynor, so the seal on your Amarr gets matched to the door it actually sits on. If you want to talk about your seal or any other part of your door, call (844) 797-3654 for a free estimate. We answer the phone with a real person, day or night, and emergency calls get a named technician on the way.
Written by the team at Servo Garage Doors Summerlin, serving Summerlin and nearby areas.