A Servo company - serving Summerlin, NV

Clopay Opener Logic Board Repair in Summerlin, NV

Raised-panel steelRaised-panel steel
Carriage houseCarriage house
Modern flushModern flush
Full-view glassFull-view glass
LiftMaster openersLiftMaster openers
Chamberlain openersChamberlain openers
Every visit starts with

Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included

We have financing partners for your new garage door*On approved credit; ask us about your options

You get a price before we start. It does not change when the pro arrives.

Get your free estimate

Clopay Opener Logic Board Repair: The Summerlin Owner’s Guide

Clopay opener logic board repair in Summerlin usually runs $120 – $320 installed, and most straightforward board swaps are finished the same day we’re dispatched. The logic board is the circuit board inside your opener housing that reads the safety sensors, fires the motor relay, and holds the travel limits in memory. Owners typically discover it’s gone when the door stops responding to remotes and the wall button at the same time, or the opener clicks once and nothing moves. We photograph the failed board before we quote a replacement – Clause 4 of The Haven Standard – so you see the scorched relay or corroded trace yourself.

Call (844) 797-3654

Which Clopay Models This Applies To

Clopay is best known for its door lines, but Clopay also sells garage door openers, and the logic board part number is tied to the opener series, not the door. The label on the back or underside of the opener housing carries the model and serial – that sticker is what we match the board against, because two openers that look identical from the outside can carry completely different boards inside.

Older Clopay units that used a screw-drive motor often share a board family across a few model numbers. Newer belt and chain units changed the sensor logic, so a board from a different series may physically fit the connector but won’t read the safety beam correctly. That’s the compatibility gotcha most Summerlin homeowners run into: the board slots in, the opener powers up, and the door still reverses at the floor because the wrong board is sending the wrong sensor signal.

On the OEM-versus-aftermarket question for Clopay specifically: an OEM board is matched to your exact serial, while a quality aftermarket equivalent covers a range of years. The aftermarket route runs cheaper and works, but only if the seller lists your model number explicitly. If it says “fits most Clopay openers,” that’s the one that fails in three months.

Explore

Styles & brands we work with

  • Raised-panel steel
  • Carriage house
  • Modern flush
  • Full-view glass
  • LiftMaster openers
  • Chamberlain openers

Signs Your Clopay Opener Logic Board Repair Is Failing

Technician performing professional garage door spring repair and maintenance
Signs Your Clopay Opener Logic Board Repair Is Failing
  • Remote and wall button both dead. If the handheld remote and the hardwired wall button fail together, the receiver and the wall circuit are both suspect. The logic board handles both, which is why this pattern points at the board rather than the remote.
  • One click, then silence. The board fires the motor relay, so a single click with no motor movement usually means the relay is toast. A failing relay on a board shows as a darkened spot on the component.
  • Door reverses before it hits the floor. The board reads the safety sensor signal. If the sensors are clean and aligned but the door still backs up, the board’s sensor input has failed, not the sensors.
  • Travel limits won’t hold. Set the open and close travel, and the door overshoots the next morning. That’s a board that’s losing its memory on power cycles, often from a failing memory chip or a weak internal battery on the board.
  • Nothing happens after a power blip or a lightning season. Summerlin’s afternoon monsoon storms push surges through the panel, and a board that survives the surge often loses a capacitor. The opener stays dark even though the outlet is live.

One honest note on safety before you touch anything: the logic board itself runs on low voltage and a board swap is not a shock hazard when the opener is unplugged from the wall. But the opener housing sits under spring tension and the door must be fully closed and disconnected from the opener before you reach into it. If you’re not sure how to release the trolley, that’s the point to stop and call.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade
BeforeBefore
AfterAfter

Replacement Cost & What’s Included

Logic board repair or replacement in Summerlin lands inside our opener repair range of $120 – $320 installed. Most jobs come in near the middle of that range, and the spread is driven by three things: whether the board is OEM or a matched aftermarket equivalent, whether the opener model is still in production, and whether the trolley or belt needs attention while the housing is open.

The price you see is the price you pay. We deliver a flat, written price and written scope before any work starts – Clause 1 of The Haven Standard – and we don’t move it once we’re on the ladder. Parts and labor are rolled into that number instead of billed separately at the end. Our technicians have up to 11 years of experience, and every logic board replacement closes with a documented photo record of the failed board and the installed replacement, plus our 365-Day Done Right Promise if the repair doesn’t hold. If another company has already quoted you a board replacement, bring that paperwork and we’ll provide a free second opinion.

DIY or Call Us?

professional garage door repair service
DIY or Call Us?

There’s a safe slice of troubleshooting you can do yourself. Unplug the opener, check the wall outlet with a lamp, confirm the safety sensors are lit and aligned, and replace the remote battery. Look at the breaker feeding the garage circuit. If the door runs fine by hand release but the opener is dead at every button, the board is the likely suspect and the rest of the diagnosis needs a meter.

Where DIY goes wrong: ordering a board before you’ve read the model label, swapping a board without disconnecting the door from the trolley, and wiring the safety sensor leads into the wrong terminals. Any one of those can leave you with a door that closes on a car or an opener that mistakes every passing shadow for an obstacle. We service Clopay openers across Summerlin, and we also handle LiftMaster, Chamberlain, and Genie units on the same visit. Servo Garage Doors Summerlin is an independent service provider and isn’t affiliated with Clopay – we work on the equipment, not on behalf of the factory.

For a live person on every call, including emergency opener calls, ring (844) 797-3654. We’ll photograph the board, quote a written price, and get you sorted.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Need Garage Door help nationwide? Licensed & insured · within the hour response · free estimates
Call (844) 797-3654
Local Service Coverage

Request a Free Estimate in Summerlin

Tell us what you need - Servo Garage Doors Summerlin responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch