Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateClopay Torsion Spring Replacement: The Summerlin Owner’s Guide
We replace Clopay torsion springs in Summerlin for a flat, written price of $180 – $340 installed, and most single-spring failures are handled the same day you call. The torsion spring is the coiled steel bar above your door that carries its weight – when it snaps, the door becomes too heavy for the opener to lift and usually won’t open at all. Owners in Summerlin typically discover this at the worst moment: a loud bang from the garage, a door stuck half-open, or a car stranded inside on a weekday morning. We answer live, day or night, and we photograph the failed spring before anyone quotes a replacement.
Key takeaways:
- Installed Clopay torsion spring replacement in Summerlin: $180 – $340, quoted in writing before work starts.
- We replace single and double spring setups, and match wire diameter and length to your specific Clopay door.
- Same-day repair is standard for spring failures; emergency calls are answered by a live person around the clock.
- We’re an independent service provider, not affiliated with Clopay – but we match their factory specs.
Which Clopay Models This Applies To
Clopay torsion springs are sized to the door’s weight and height, not to a single universal part. That means the replacement for a Clopay Gallery Collection door in The Ridges is very likely a different wire diameter and length than the spring on a Clopay Avante or Classic Series door a few streets over in Summerlin. The good news is that the sizing logic is consistent across their lineup: coil count, inside diameter, wire gauge, and overall length determine the spring, and the label on the door or the spring’s own measurements tell us which one you need.
We ask three things when you call. First, the model line if you know it (Gallery, Coachman, Avante, Classic, or a Canyon Ridge). Second, the door width and height. Third, whether your setup is single-spring or double-spring. If you don’t know, we measure on-site before we touch anything. On the OEM-versus-aftermarket question, Clopay-branded springs are one option, and quality aftermarket springs matched to the same wire diameter and cycle rating are another – both work, and we’ll tell you which is available and what each costs so you’re choosing on facts, not pressure.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Clopay Torsion Spring Replacement Is Failing

Most Clopay spring failures announce themselves before the final break. Here’s what to listen for and look for:
- A loud bang from the garage. That’s the sound of the spring snapping – the door will feel dramatically heavier the next time you try to lift it manually.
- The door opens a few inches and stops. The opener is straining against a door it can no longer lift; the spring, not the motor, is usually the culprit.
- A visible gap in the coil. Look at the spring above the door – a clean break in the coil is the classic failure sign and means replacement, not repair.
- The door slams down or feels too heavy to lift by hand. A weakened spring stops counterbalancing the door’s weight, shifting all that load onto you and the opener.
- Uneven opening or a door that drifts. One spring failing in a two-spring setup leaves the door off-balance, which strains cables and rollers too.
Summerlin’s dry heat and the temperature swings between a 110-degree afternoon and a cool desert night put real stress on torsion springs. We see spring fatigue show up here faster than in milder climates, so a spring that’s several years old and starting to show any of these signs is worth checking before it fails completely.
Before
AfterReplacement Cost & What’s Included
Here’s the honest range. Installed Clopay torsion spring replacement in Summerlin runs $180 – $340. That covers the spring itself, labor, and tensioning to the correct specs for your door. The range depends on three things: whether you have one spring or two, the wire diameter and cycle rating of the spring your door requires, and whether the job is a straight single-spring swap or part of a larger repair.
Nobody quotes you a price over the phone before seeing the door. We measure the spring and photograph it first, then hand you a flat, written price and a written scope before any work starts. That’s not a sales line – it’s how we operate on every job. The price we write down is the price you pay.
Every spring replacement comes with our 365-Day Done Right Promise: if the repair isn’t right, we make it right. And you leave with a documented photo record of what we found and what we did, so there’s no question later about what was replaced.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?

This is one part you should not attempt yourself. A torsion spring under tension stores enormous energy – if it slips while you’re working on it, it can cause serious injury. We say that plainly because it’s true, not to scare you into calling. There’s a reason spring replacement is one of the few garage door jobs we treat as strictly off-limits for homeowners.
What you can safely do: look at the spring for a visible break, listen for the bang, and confirm whether the door is too heavy to lift by hand. Then call us at (844) 797-3654. We’ll get a technician out, photograph the failed spring, and quote you a written price before touching a tool. Spring repairs like this are usually handled same day, and live phone coverage means you reach a real person whenever you call.
FAQs
Most Clopay torsion springs are rated for cycles, not years – a standard spring handles roughly 10,000 cycles, which averages several years of normal use. In Summerlin’s heat, expect the upper end of that usefulness to arrive sooner than it would in a cooler climate, so treating a multi-year-old spring as a wear item rather than a forever part is realistic. Call (844) 797-3654 for a free estimate on replacement.
No – a snapped torsion spring must be replaced, not repaired, because the steel has failed structurally and there’s nothing safe to patch. We replace it with a spring matched to your door’s specs. Call us for a written price before any work.
A single-spring replacement typically takes under an hour on-site, once we’ve measured and confirmed the right spring. Double-spring setups can take a bit longer. We’ll give you the timing when we quote.
We determine the spring by measuring wire diameter, inside diameter, coil length, and cycle rating to match your specific Clopay door, then obtain that exact spec. We don’t stock parts on a truck – we confirm the right spring and order it if needed, which is why accuracy matters more than speed here. Call (844) 797-3654 to get started.
Written by the team at Servo Garage Doors Summerlin, serving Summerlin and nearby areas.
Ready to Get That Spring Fixed?

Call Servo Garage Doors Summerlin at (844) 797-3654 for a free estimate on your Clopay torsion spring replacement. We answer live, day or night, photograph the failed part before quoting, and hand you a flat written price before anything is touched. We’re independently owned and operated and we service all major brands – LiftMaster, Chamberlain, and Genie included – alongside Clopay. Estimates are free.