Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateRaynor Cable & Drum Replacement: The Summerlin Owner’s Guide
We replace and reset Raynor-compatible cables and drums on garage doors across Summerlin, and the typical installed cost runs $130 – $250 depending on whether you have a single torsion drum or a pair, and whether the cable is standard 7-strand or the heavier 1/8-inch stock Raynor used on its wider doors. Most of these are same-day repairs when you call before mid-afternoon. Cables and drums rarely fail quietly. Owners in Summerlin usually notice a drum that’s chewing a groove into itself, a cable that’s jumped the drum track after a hot afternoon, or a door that drops hard on one side when it closes.
Which Raynor Models This Applies To
Raynor cable and drum hardware splits cleanly by drive type. Raynor sectional doors built on the Reliant, TradeMark, and ShowCase lines – the residential doors most Summerlin homes have – use standard torsion drum kits sized to the door’s wire-gauge spring system. Raynor’s Distinction and A-Door lines occasionally use a wider-track drum that won’t take a generic replacement, and Raynor commercial doors use a different drum entirely. The fastest way to identify yours: look for the model label on the inside of the top section, right side, and measure the drum’s outer diameter and the cable’s diameter with calipers. If you’re stuck, the spring’s coil count plus the door’s width and height will narrow it down.
On the OEM-versus-aftermarket question: Raynor’s own replacement drums are the safest match for a door still under warranty or one with the wider-track setup. For older Raynor setups in Summerlin where the OEM part is discontinued, a quality aftermarket drum from a supplier who matches the original’s hub bore, bearing, and cable groove specs is the practical answer. What we won’t do is cross a Raynor drum with an off-size cable and call it done – that’s a setup for premature wear.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Raynor Cable & Drum Replacement Is Failing

- A cable jumping its drum groove. The drum’s cable groove wears wider with age until the cable slips off the track. Once it jumps, the door is unbalanced and should not be operated.
- A cable that’s frayed or kinked on one side. Raynor’s standard 7-strand cable loses strength as individual strands fray. A kink on one side means the drum is misaligned or the door’s tracking is off.
- A drum making a grinding or popping sound. The drum’s bearing is worn or the drum is loose on its shaft. The popping comes from the drum slipping under tension.
- A door that drops hard on one side before it closes. When one cable or drum fails, the door’s weight shifts to the other side. This is a balance failure, not a track problem.
- Visible metal shavings or rust streak around the drum hub. This is the drum bearing grinding itself apart. Left alone, a seized drum can snap the cable under full tension.
See the difference
Before
After
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Raynor cable and drum replacement in Summerlin, our installed price ranges land at $130 – $250 for the standard job. Here’s what moves you toward the top of the range:
- Paired replacement (both drums, both cables) on a wide or double-car Raynor door: more labor, more parts.
- Heavier cable stock or a wider-track drum for the Distinction or A-Door line.
- Door realignment needed after a jumped cable.
The range includes parts, labor, drum-spring-cable rebalancing, and a post-repair safety check. The price you get is a flat written price with a written scope before we start – no exceptions. Every job closes with a photo record of the failed part and the finished work. Our 365-Day Done Right Promise covers the repair under The Haven Standard, so if it isn’t right, we make it right.
DIY or Call Us?

You can safely inspect: look for the drum groove wear, check the cable for frayed strands, and confirm the door’s balance by disconnecting the opener and lifting by hand once. If you’re seeing frayed cable or a worn drum, stop there. The two things you should not DIY: cable and drum and torsion spring work. Those components are under hundreds of pounds of tension, and a slipped cable or a released drum can cause serious injury. This is the part of the trade where we tell homeowners plainly: call a professional. Replace a drum or reset a cable wrong and the door is unweighted on one side – that’s a door at risk of falling.
If you want a free estimate, call us at (844) 797-3654, or text us and we’ll text back.
FAQs
Five to ten years is typical on a Raynor residential door, but Summerlin’s heat and dry-dust cycle speeds that up. The sun-side cable and drum wear faster because the door section expands and contracts more on the exposed side, and dust works into the drum hub bearing. If you’re seeing cable fray at year six, that’s normal for this climate.
Sometimes – a slightly worn drum can be re-grooved and a chewed cable replaced, but a cracked hub, seized bearing, or a drum that’s been re-grooved twice is a replace-not-repair job. We’ll tell you which one it is after inspecting. If repair gets you another two seasons, that’s the honest call. Call (844) 797-3654 for a free estimate.
Usually 45 minutes to 90 minutes for a paired replacement on a standard Raynor residential door. The extra time is for realignment and rebalancing once the new drum and cable are on – the door has to come back to even weight before we hand it over.
We match to your Raynor model and the drum’s measured dimensions – the hub bore, bearing, and cable groove – then source from a supplier that carries Raynor-spec hardware. If the OEM part is discontinued for an older Raynor, we use a quality aftermarket equivalent matched to spec and tell you exactly what we’re installing. Nothing goes on the door without the specs lined up. Call (844) 797-3654 for a free estimate.
Written by the team at Servo Garage Doors Summerlin, serving Summerlin and nearby areas.
Servo Garage Doors Summerlin is an independent service provider and is not affiliated with Raynor. We service all eight major brands, including LiftMaster, Chamberlain, and Genie. For Raynor cable and drum replacement in Summerlin, call (844) 797-3654 for a free estimate.